Course contentsShow
← Mathematics
Lesson 1657 of 3,12137. Applications of IntegrationFree lesson

Washer Method: Introduction and Setup

Understanding washers as disks with holes and setting up V = π∫([R(x)]² - [r(x)]²) dx for annular cross-sections.

Washer Method: Introduction and Setup

What You'll Learn

You'll learn how to find volumes of solids of revolution when there's a "hole" in the middle, using the washer method formula.

The Problem: Solids with Holes

So far, you've used the disk method to find volumes when rotating a region around an axis. But what happens when the solid has a hollow center—like a donut or a pipe?

That's where the washer method comes in.

Understanding Washers

A washer is simply a disk with a hole punched out of the center. Imagine a flat circular washer you'd find in a hardware store—it has an outer radius and an inner radius.

When you rotate a region between two curves around an axis, each cross-section perpendicular to the axis forms a washer shape:

  • The outer radius R(x) is the distance from the axis to the outer curve
  • The inner radius r(x) is the distance from the axis to the inner curve

The Washer Method Formula

The volume of a single washer is: Volume of washer=π[R(x)]2−π[r(x)]2=π([R(x)]2−[r(x)]2)\text{Volume of washer} = \pi[R(x)]^2 - \pi[r(x)]^2 = \pi([R(x)]^2 - [r(x)]^2)

This makes sense: it's the area of the big disk minus the area of the hole.

To find the total volume, we integrate: V=π∫ab([R(x)]2−[r(x)]2) dxV = \pi \int_a^b ([R(x)]^2 - [r(x)]^2)\,dx

Or, if rotating around a horizontal line and integrating with respect to y: V=π∫cd([R(y)]2−[r(y)]2) dyV = \pi \int_c^d ([R(y)]^2 - [r(y)]^2)\,dy

Setting Up Problems

The key steps:

  1. Sketch the region and identify which curve is farther from the axis (outer) and which is closer (inner)
  2. Identify R(x) = distance from axis to outer curve
  3. Identify r(x) = distance from axis to inner curve
  4. Set up the integral using the washer formula

Key Takeaway: The washer method extends the disk method to handle annular (ring-shaped) cross-sections by subtracting the squared inner radius from the squared outer radius.