Raspberry Pi and Edge Boards Setup
You'll learn how to configure Raspberry Pi and similar edge boards to run computer vision models with proper environment setup, model loading, and camera integration.
Why Edge Boards for CV?
Edge boards like Raspberry Pi, NVIDIA Jetson Nano, or Google Coral Dev Board bring AI inference directly to the device—no cloud required. Think of them as mini-computers optimized for running lightweight models in remote locations, IoT devices, or anywhere low latency and privacy matter.
Environment Setup
Start by preparing your edge board's operating system (usually Linux-based). Install Python and essential libraries:
# On Raspberry Pi OS
sudo apt-get update
sudo apt-get install python3-pip python3-opencv
# Install inference runtime (example: ONNX Runtime)
pip3 install onnxruntime
For hardware accelerators (covered previously), you may need vendor-specific SDKs—like TensorRT for Jetson or Coral's Edge TPU runtime.
Model Loading
Load your optimized model (ONNX, TensorFlow Lite, etc.) into memory efficiently:
import onnxruntime as ort
# Load model optimized for edge
session = ort.InferenceSession("model_optimized.onnx")
Memory is limited on edge devices, so use quantized or pruned models from your optimization pipeline.
Camera Integration
Connect a USB or CSI camera module and capture frames:
import cv2
# Initialize camera (CSI or USB)
cap = cv2.VideoCapture(0)
ret, frame = cap.read()
# Preprocess and run inference on frame
Adjust resolution and frame rate based on your model's latency requirements and the board's processing capability.
Key Takeaway: Edge board setup involves installing the right runtime environment, loading optimized models efficiently, and integrating camera hardware—all while respecting the device's memory and compute constraints.